If you have questions about the materials compatible with your WonderPress, you can read this article and refer to the corresponding tableto find all the information you need.

No. Sublimation only bonds to polyester or a sublimation-coated surface; on untreated cotton the color won't hold. For 100% cotton, use HTV or DTF instead. DTF carries its own white base layer, so it works on dark garments too.

PVC and other vinyl-chloride materials — heating them releases corrosive fumes. Anything of unknown composition: unlabeled foam, unbranded film, mystery plastic. No food, in any module, ever. And nothing flammable, explosive, sealed or pressurized — WonderPress reaches up to 400°F. Note that printable adhesive vinyl is not the same thing as heat-press-safe vinyl, so check the spec before you buy.

Start from the built-in presets, but treat them as a starting point — sheet thickness, batch variation and even room humidity move the result, so run one test piece before a full batch. Check whether your film is hot-peel or cold-peel; peeling at the wrong moment looks exactly like a temperature problem and costs people hours of re-tuning. Then let the finished piece cure 24 hours before its first wash — inside out, cold water, gentle cycle, no dryer, no fabric softener.

It depends on the material. HTV needs no printer at all — cut, weed, press. Sublimation blanks need a sublimation printer and sublimation paper. Phone cases and badges need a sublimation printer plus sublimation transfer film, which is not the same as flat sublimation paper — check your printer takes that sheet size before you buy. DTF transfers need a DTF printer and hot-melt adhesive powder.